Difference between revisions of "FAS"

From JacobDNS
Jump to navigation Jump to search
Line 37: Line 37:
  
 
= Bell=
 
= Bell=
: The Buzzer is used to make your neighbors upset...
+
: The Bell is used to make your nearby people upset
 
: Of course, you can use it to inform people they need to get out of the oven.
 
: Of course, you can use it to inform people they need to get out of the oven.
  

Revision as of 15:07, 30 November 2020

FACU - Fire Alarm Control Unit

The first steps on setting everything up is to have your FACU set up.
The FACU is used to control your network of fire alarms that are configured to it.

To Setup

Follow these steps to setup your FACU.
  1. Rez out the "[JAC] Fire Alarm Control Unit".
  2. Right Click and go into the object's contents.
  3. Edit the notecard "Application.Config".
  4. Enter an Alarm ID. (This is used to link alarms together).
  5. Enter a group setting.


Operation

Suppression

Not Yet Implemented

Reset

Resetting your FACU will turn everything off in the system and rearm it.
When you're done with the alarms and don't need them on anymore, this is what you should press to reset them back to Normal Status

Drill

Don't you love when your employees see you heading towards that alarm panel? DRILL TIME
When you do a drill on the Annunciator, it will not send a tone out on Discord

Pull Station

The pull station is used to set off the alarms in case of an emergency.
Make sure this is out in the opening or people might burn.

To Setup

Follow these steps to setup your Fire Alarm Notification Station.
  1. Rez out the "[JAC] FAS Manual Notification Station".
  2. Right Click and go into the object's contents.
  3. Edit the notecard "Application.Config".
  4. Enter an Alarm ID (This is used to link alarms to the FACU).

Bell

The Bell is used to make your nearby people upset
Of course, you can use it to inform people they need to get out of the oven.

To Setup

Follow these steps to setup your Bell
  1. Rez out the "[JAC] FAS Fire Alarm Notification Appliance(Bell)".
  2. Right Click and go into the object's contents.
  3. Edit the notecard "Application.Config".
  4. Put the Alarm ID from your Fire Alarm Control Unit. Then Save.

Smoke Detector

Fire Sprinklers

Not Yet Implemented

Discord Relay

Setup Instructions will be put here for the discord relay